Forest River Solera – AC Capacitor & Fan Motor Service

Forest River Solera – AC Capacitor & Fan Motor Service

by

Complete repair guide for the Forest River Solera – AC Capacitor & Fan Motor Service. Follow these steps to diagnose and fix the issue yourself.

Parts & Tools You’ll Need

Step 1: Diagnose AC Performance Issues

Begin by running your Forest River Solera’s AC system for 10-15 minutes while monitoring cooling performance and listening for unusual noises from the rooftop unit. Use the non-contact infrared thermometer to measure the temperature differential between the air return and supply vents—a healthy system should show a 15-20°F difference. If you’re hearing a humming sound without the fan running, or if cooling has dropped significantly, the capacitor or fan motor is likely the culprit.

Step 2: Safely Disconnect Power and Access Unit

Turn off the main AC breaker at your RV’s electrical panel and verify power is disconnected using a multimeter set to AC voltage mode on the thermostat wires. Climb onto your roof using a sturdy ladder and safety harness, then locate the rooftop AC shroud fasteners (typically 4-6 screws or bolts). Remove the rooftop AC shroud/outer cover carefully, setting all hardware aside in a marked container to prevent loss.

Step 3: Remove and Test the Capacitor

Locate the RV AC dual run capacitor mounted on the compressor/motor assembly—it’s a cylindrical component approximately 3-4 inches tall. Before touching it, discharge any residual electrical charge by using an insulated screwdriver to short the terminals together briefly. Photograph the wire connections for reference, then disconnect the two or three terminal wires and remove the mounting bracket bolt to extract the old capacitor completely.

Step 4: Replace Capacitor and Fan Motor Assembly

Install the new RV AC dual run capacitor by reconnecting the terminal wires in the exact sequence you documented—polarity matters for proper operation. If the fan motor requires replacement, unbolt it from the compressor housing (typically 2-3 mounting bolts) and disconnect the power lead wire. Insert the new rooftop AC fan motor, secure with all bolts torqued to manufacturer specs (usually 8-12 ft-lbs), and reconnect the power lead to the appropriate terminal.

Step 5: Clean Coils and Straighten Fins

Spray the AC evaporator/condenser coil cleaner foam across the entire condenser coil surface, following product instructions for dwell time (typically 5-10 minutes). Use the fin comb/coil straightener tool to carefully straighten any bent aluminum fins, working from top to bottom in gentle, overlapping strokes to restore proper airflow. Rinse the coils thoroughly with clean water from a spray bottle or low-pressure hose to remove all cleaner residue and debris.

Step 6: Reinstall Shroud and Seal Roof Opening

Position the rooftop AC shroud back over the unit, ensuring the flange sits properly and evenly around the roof opening. Apply the AC roof gasket and self-leveling sealant in a continuous bead around the mounting flange, then install all fasteners in a cross-pattern (like tightening a wheel) to ensure even pressure and proper seal. Allow the sealant to cure for the full time specified on the product label before exposing the unit to weather or water.

Step 7: Test System and Verify Performance

Restore power at the main breaker and turn on the AC system, listening for the fan motor to engage smoothly within 10-15 seconds. Measure return and supply air temperatures again with the non-contact infrared thermometer—you should see the 15-20°F temperature differential restored. Run the system for at least 30 minutes and check that the RV AC thermostat/control board cycles normally and maintains your set temperature without erratic behavior.