Complete repair guide for the Brinkley Model Z – Furnace Igniter & Control Board Replacement. Follow these steps to diagnose and fix the issue yourself.
Parts & Tools You’ll Need
- Suburban/Atwood RV furnace replacement unit
- Furnace igniter electrode assembly
- Furnace sail switch
- Furnace circuit board / control board
- Furnace high-limit switch
- Furnace blower motor (12V DC)
- Propane/CO combo detector alarm
- Digital multimeter (auto-ranging)
Disclosure: This post contains affiliate links. We may earn a commission on qualifying purchases at no extra cost to you.
Step-by-Step Repair Guide
Step 1: Diagnose Furnace Ignition Failure
Begin by ensuring your RV is parked on level ground with the propane tank valve closed and all electrical systems powered down. Use your digital multimeter to test the control board for voltage output—if you’re getting zero volts to the igniter electrode, the control board likely needs replacement, while a weak igniter spark indicates a faulty electrode assembly.
Step 2: Disconnect Power and Propane
Turn off the main battery disconnect switch and ensure the propane tank valve is fully closed before proceeding with any furnace work. Wait at least five minutes to allow any residual pressure in the propane lines to dissipate, ensuring a safe working environment for component removal.
Step 3: Remove Old Igniter Electrode
Locate the igniter electrode assembly inside the furnace combustion chamber and carefully disconnect the wire harness by gently twisting and pulling the connector. Remove the mounting bracket bolt using an appropriate wrench, then slide the old electrode out slowly to avoid damaging surrounding components.
Step 4: Install New Control Board Assembly
Remove the old circuit board by disconnecting all wire harnesses and unbolting the mounting plate from the furnace housing. Carefully position the new control board in the same orientation, reconnect all harnesses to their corresponding terminals, and secure the mounting bolts firmly to prevent vibration-related failures.
Step 5: Attach Replacement Igniter Electrode
Position the new igniter electrode assembly into the mounting bracket and tighten the bolt securely without over-torquing, which could crack the ceramic insulator. Reconnect the wire harness to the electrode terminal, ensuring the connection is tight and the wire routing doesn’t interfere with any moving furnace components.
Step 6: Verify Sail Switch and Safety Switches
Check that the furnace sail switch (air pressure switch) moves freely and isn’t obstructed by debris or corrosion, as this prevents ignition if airflow is inadequate. Inspect the high-limit switch for proper mounting and confirm the blower motor spins freely by giving it a gentle manual rotation.
Step 7: Test Complete Furnace System
Reconnect the propane tank valve, restore battery power, and set the RV thermostat to heating mode while listening for the blower motor activation and igniter spark. After 30 seconds of successful ignition, verify the Propane/CO combo detector shows no alarms, and check your multimeter readings match the manufacturer’s specifications for control board output voltage.
Recommended Parts
| Part | Link |
|---|---|
| Suburban/Atwood RV furnace replacement unit | View on Amazon |
| Furnace igniter electrode assembly | View on Amazon |
| Furnace sail switch | View on Amazon |
| Furnace circuit board / control board | View on Amazon |
| Furnace high-limit switch | View on Amazon |
| Furnace blower motor (12V DC) | View on Amazon |
| Propane/CO combo detector alarm | View on Amazon |
| Digital multimeter (auto-ranging) | View on Amazon |